9'0 X 22.25" X 18" X 14.5" X 2 7/8"
This is my comp I use this in bigger waves or when I compete. I use this board from 3ft to 15ft Puerto Escondido. It is a great all around board for the advanced surfer. These boards allow me to surf agressively and noseride in almost all conditions. This is an advanced board with a slight concave in the nose, lowered rails and double barrel concave in the tail. It has a semi rounded tail and comes in a 2+1 or quad set up...I use either the R4 side bites with the 5 inch RFC rake or I will use the RS3 and an Isaac Wood model 6.0 RFC fin
9'1 X 23" X 18.5" X 15" X 2 7/8"
We also devoloped a version with a wider tail when the waves get mushy. This board has all the characteristics of the above board with just a bit more width.I use either the R4 side bites with the 6.0 inch RFC rake or I will use the RS3 and an Isaac Wood model 6.5 RFC fin
9'1 X 19 3/4" X 12 7/8" X 12 1/4"X 3" Puerto Gun
This board was made by Ernie Higgins He made it for me when I did the puerto tube riding contest. I use this board when it gets big at blacks coronado or Simmons when its big... It is really fast pulled in nose with slight v in the tail. I use two Rs3 side bites with the 6.5 RFC center fin.
6'0 X 20 1/2" X 16" X 2.1" Toad This is a fun small wave board it is set up as a quad and has a concave deck with double barrel concave in the tail. this board shreds on little down the line beachbreaks. I use the R6 side fins and the Rs3 side bites in bamboo.
5'11 X 21" X 17.5" X 2 5/8" Dwart This is one of my favorite shortboards this board is meant to be ridden 6 inches shorter then your normal shortboard. it has the volume of a big board but the reactiveness of a short board it is really wide with a round tail that holds really well. It is a 5 fin which allows me to use it as a quad or trifin. I either use the R6 side fins and the Rs3 side bites in bamboo as a quad or I will use the R6 side fins and an R4 center.
6'3 X 20 3/4" 16.5" x 13.5" x 2 5/8" Slayer This is my all around shortboard I ride this at Windan and the Rock. its a little chunky but is made to be ridden 3-4 inches smaller then your normal shortboard. It is also a 5 fin. Its fast and reactive its just an all around great shortboard... I use R4's as a tri and the R6 side fins and the Rs3 side bites in bamboo as a quad
9'6 X 27.5" X18.5" X 16.5" X 3.7/8" SUP
I mostly use this as a crosstrainer for big waves and my Biking. I get an awesome endurance work out on it and the board works great when you have your own little secluded beach where nobody can be in your way. It noserides decent and turns on a dime. The blank is eps and has a future fin set up. I use a two R5's and a 5.5 Rusty RFC center fin.
10' x 24.25" x 19.5" x 16.5" x 2 7/8"
Noserider " Jellyphish"
This is a board that Rusty, Hoy Runnels and I have been working on. The board is a Noserider that is its main purpose. It has low entry concave dissolving into a small flat spot which then turns to a slight displacement hull towards the tail with a little flip upwards at the tail block. This creates very little drag while noseriding.
The board has a ton tail rocker which allows the board to flex and counter act the gravity effect, When the tail is pushed down the nose raises (like a Skateboard) It also helps in turning the board not only does my board no seride but it turns like a 9'6... I use a 10" RFC Azul or a 9.5" Isaac Wood Model RFC longrake
10' X 24" X 18.75" X 16.25" X 2 5/8"
This is escentially the same board as the board above just 1/2" thinner and 1/4" narrower throughout the board. this board works great for faster punchier small waves for speedy noserides and still having the ability to turn.I use a 10" RFC Azul or a 9.5" Isaac Wood Model RFC longrake